Alpha-technologies PowerAgent SC3 Manual do Utilizador descarregar pdf (Página 36)

PowerAgent

SC3 Site Controller Document # 700-000014-01 Rev 2

Installation and Operation

Phoenix Broadband Technologies, LLC 10/28/2010

Page 36 of 57

If the battery sensor is

equipped with the

electrolyte level

detection option the

Electrolyte Level will

be displayed as either

“Normal” or “Low”. If

the sensor is not

equipped with this

option the Electrolyte

Level will not be

displayed.

For High Voltage

sensors only the

Sensor Address is

shown for sensor

identification.

The Sensor Status

provides an indication

of what is happening

at the sensor. The

table below lists the

possible values of the

Sensor Status.

Sensor Status Description

Normal This sensor is operating normally

Fault There is no communications with this sensor

Measuring This sensor is making an admittance measurement

SensorDisabled This sensor was disabled through SNMP

StringDisabled This string was disabled through SNMP

Missing This sensor was expected based on the string voltage, but is not present

MeasurementFailed

The last admittance measurement failed

Admittance measurements are normally made at a rate set by the Admittance Measurement

Interval set in the Site Setup Display. Pressing the Measure Now button will initiate an

admittance measurement on this sensor the next time it is polled. The measurement may take a

minute to start depending on what the Site Controller is doing at the time. When the

measurement starts the Sensor Status will indicate “Measuring”. The status will return to normal

when the measurement is complete.

Pressing the Flash LED button commands the battery sensor to flash its LED alternating

between Red and Green. The Sensor LED Control indicator displays the state of the LED either

“Normal” or “Flash Green/Red”. Additional LED states can be set by the SNMP Manager. The

flashing LED can help onsite personnel locate a jar in a large deployment. Depending on what

the Site Controller is doing it may take a minute for the LED to start or stop flashing when the

button is pressed.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 56 57

Comentários a estes Manuais

Sem comentários

Alpha-technologies PowerAgent SC3 Manual do Utilizador Página 36

Comentários a estes Manuais

Manuais e produtos relacionados com Software Alpha-technologies PowerAgent SC3