Alpha-technologies GEM Manual do Utilizador Página 1

Technical ManualEffective: April 2008Alpha TechnologiesGEMGenerator Expansion Module

745-872-C0-002, Rev. B102.0 Installation, continued2. Position the bracket so both .2" half shears are equally spaced and hanging below the bott

11745-872-C0-002, Rev. B2.0 Installation, continued2.1 Installing the Enclosure Ground Wire1. Slide the battery slide tray out and verify the area b

745-872-C0-002, Rev. B122.0 Installation, continued2.2 Installing the GeneratorPlace the generator in the enclosure with its feet inside the foot rec

13745-872-C0-002, Rev. B3.0 Operation Using the Line Transfer Switch (LTS)Alpha's recommended confi guration of the GEM enclosure uses a line tra

745-872-C0-002, Rev. B14CAUTION!Before drilling, verify the areas behind the drilling locations are free from batteries, wiring, or equipment.Fig. 2-3

15745-872-C0-002, Rev. B3.0 Operation Using the Line Transfer Switch (LTS), continued3.1 Installing the LTS, continued4. Route the cord into the GE

745-872-C0-002, Rev. B163.0 Operation Using the Line Transfer Switch (LTS), continued3.2 Operation1. Refer to the generator's operation manual

17745-872-C0-002, Rev. B4.0 Operation Without Line Transfer SwitchThe following procedure is for operating a generator in the GEM enclosure without a

PowerAlpha Technologies®Due to continuing product improvements, Alpha reserves the right to change specifi cations without notice. Copyright © 2008 Alp

PowerAlpha Technologies®

member of The GroupTM Generator Expansion Module (GEM)Technical Manual745-872-C0-002, Rev. BEffective Date: April 2008Copyright© 2008Alpha

745-872-C0-002, Rev. B4Table of ContentsSafety Notes ...

5745-872-C0-002, Rev. BFigures and TablesFig. 1-1, Generator Expansion Module...

745-872-C0-002, Rev. B6Safety NotesReview the drawings and illustrations contained in this manual before proceeding. If there are any questions regard

7745-872-C0-002, Rev. BGeneral Safety PrecautionsTo avoid injury:• This enclosure and its hardware must only be serviced by authorized personnel.• T

745-872-C0-002, Rev. B81.0 IntroductionThe Generator Expansion Module (GEM) extends runtime for PWE-3 and PWE-6 pole-mount enclosures. The GEM instal

9745-872-C0-002, Rev. B1. Locate the mounting holes on the lower left and right side of the PWE enclosure. Use the 1/4" drill bit to clear the p